I remember being in the same spot with a heavy workstation card a while back. Watching the PCB slowly tilt during a stress test was honestly terrifyin...
To add to the point above: Ive been following this thread and think weve covered a lot of ground regarding aesthetic and budget choices. Looking at th...
Honestly, for something as beefy as a 5080, you really need to look at the actual wire gauge. I always recommend 16AWG tinned copper for these high-po...
Tbh the Tomahawk is king, but the ASRock B650 PG LIGHTNING ATX is my go-to for budget builds. It is super stable and handles the 7800X3D power draw li...
I had the exact same dilemma right after I unboxed mine! Honestly it felt like I was spending more time managing my setup and hunting for batteries th...
I'm super satisfied with my Gigabyte B650 board!! - B650: Solid VRMs/value. - X670E: Highkey overkill. Basically, B650 works well and I've h...
Honestly, just a quick thing to double-check since youre doing the build yourself—make sure youre looking specifically at RDIMMs. The 7000-series Thre...
- Honestly, I recommend Skull & Co. NeoGrip for Switch OLED. In my experience, it's the most reliable option, tho u should be cautious about the fit i...
Quick question - what's your actual budget limit? honestly, i was disappointed with single-card setups for anything bigger than 7B models. basically, ...
Saving this thread
Seconding the recommendation above. DDR6 is basically just for GPUs right now, so dont sweat that. For a modded server, CAS latency ACTUALLY matters c...
Quick question - what kind of desk surface are you working with? Honestly, it matters more than people think for stability! Before I dive into technic...